In a reaction, an alkanol B was converted to pent-2-ene

In a reaction, an alkanol B was converted to pent-2-ene
(a) Give the structural formula of alkanol B.
(b) Name (i) the type of reaction that converts alkanol B to pent-2-ene.
(ii) The reagent used.

---

(b) (i)Dehydration
(ii) Concentrated sulphuric acid

---

sharon kalunda answered the question on May 17, 2019 at 11:35

Exams With Marking Schemes

• Grade 1
• Grade 2
• Grade 3
• Grade 4
• Grade 5
• Grade 6
• Grade 7
• Grade 8
• Grade 9
• PP1
• PP2
• Playgroup
• Form 1
• Form 2
• Form 3
• Form 4

Related Questions

---

• The diagram below is a set up used to investigate the effect of heat on hydrated copper(II) sulphate. Study the diagram and answer the questions that... (Solved)
  

  The diagram below is a set up used to investigate the effect of heat on hydrated copper(II)
  sulphate. Study the diagram and answer the questions that follow.
  
  (a) Why is boiling tube slanted as shown?
  (b) What is observed in the boiling tube.
  (c) Identify liquid G.

  Date posted: May 17, 2019 .    Answers (1)

• Explain why the following combination of reagents is unsuitable for the laboratory preparation of hydrogen. (Solved)
  

  Explain why the following combination of reagents is unsuitable for the laboratory
  preparation of hydrogen.
  (i) Zinc + dilute nitric acid.
  (ii) Lead + dilute hydrochloric acid.
  (iii) Potassium + dilute sulphuric acid.

  Date posted: May 17, 2019 .    Answers (1)

• Give names of the following processes used to: (Solved)
  

  Give names of the following processes used to:
  (a) Obtain a solvent from a saturated solution.
  (b) Remove steam from air
  (c) Separate zinc carbonate from water
  (d) Separate a mixture of nitrogen and helium.

  Date posted: May 17, 2019 .    Answers (1)

• Describe a simple test that can be carried out in the laboratory to distinguish between manganese (IV) oxide and copper (II) oxide. (Solved)
  

  Describe a simple test that can be carried out in the laboratory to distinguish between manganese (IV) oxide and copper (II) oxide.

  Date posted: May 17, 2019 .    Answers (1)

• State three properties common to both ammonia and calcium hydroxide solutions but different from solution of sulphur (IV) oxide in water. (Solved)
  

  State three properties common to both ammonia and calcium hydroxide solutions but different
  from solution of sulphur (IV) oxide in water.

  Date posted: May 17, 2019 .    Answers (1)

• A current of 25 amps was passed through molten aluminium oxide for 36 hrs.Calculate the amount of aluminium deposited in kg.(Al = 27, IF =... (Solved)
  

  A current of 25 amps was passed through molten aluminium oxide for 36 hrs.Calculate the amount of aluminium deposited in kg.(Al = 27, IF = 96500C)

  Date posted: May 17, 2019 .    Answers (1)

• Aluminium is extracted from its ore by electrolysis method. The current required in the process is 4,000 amperes. Study the diagram and answer the questions that... (Solved)
  

  Aluminium is extracted from its ore by electrolysis method. The current required in the
  process is 4,000 amperes. Study the diagram and answer the questions that follow.
  
  (a) Name:
  (i) Electrolyte A
  (ii) Substance D
  (iii) Electrode E
  (b) Name the material from which the electrodes are made.
  (c ) (i) Write the equation that produces aluminium metal.
  (ii) Explain why E has to be replaced from time to time.
  (iii) Why is cryolite added to the electrolyte before the process of electrolysis ?

  Date posted: May 17, 2019 .    Answers (1)

• In an experiment to determine the molar heat of neutralization of hydrochloric acid with sodium hydroride, students of Furaha Secondary school reacted 100cm³ of 1M hydrochloric acid... (Solved)
  

  In an experiment to determine the molar heat of neutralization of hydrochloric acid
  with sodium hydroride, students of Furaha Secondary school reacted 100cm³ of 1M
  hydrochloric acid with 50cm³ of 2M sodium hydroxide solution. They obtained the following results.
  Initial temperature of acid = 25.0⁰C
  Initial temperature of base = 25.0⁰C
  Highest temperature reached
  With the acid – alkali mixture = 34.0⁰C
  (a) Write an ionic equation for the neutralization reaction between hydrochloric acid
  and sodium hydroxide.
  (b ) Calculate :
  (i) The change in temperature.
  (ii) The amount of heat produced during the reaction.
  ( Specific heat capacity of solution = 4.2 kJkg-1k-1 )
  (iii) The molar heat of neutralization of sodium hydroxide.
  (c) Write the thermochemical equation for the reaction.
  (d) Draw an energy level diagram for the reaction.

  Date posted: May 17, 2019 .    Answers (1)

• Define the term molar heat of neutralization. (Solved)
  

  Define the term molar heat of neutralization.

  Date posted: May 17, 2019 .    Answers (1)

• State two uses of carbon (IV) oxide. (Solved)
  

  State two uses of carbon (IV) oxide.

  Date posted: May 17, 2019 .    Answers (1)

• State one environmental effect that excess carbon (IV) oxide in the air causes. (Solved)
  

  State one environmental effect that excess carbon (IV) oxide in the air causes.

  Date posted: May 17, 2019 .    Answers (1)

• A piece of marble chip ( calcium carbonate) is put in a beaker containing excess of dilute hydrochloric acid which is placed on a reading balance.... (Solved)
  

  A piece of marble chip ( calcium carbonate) is put in a beaker containing excess of dilute hydrochloric
  acid which is placed on a reading balance. The mass of the beaker and its contents is recorded every
  two minutes, as shown in the table.
  
  (a) Why is there a continuous loss of mass of the reaction mixture.
  (b) Write an equation for the reaction taking place.
  (c ) State two different ways by which the reaction could have been made more rapid.
  (d) Why does the mass remain constant after 8 minutes.
  (e) State the observations that would be made if a few drops of silver nitrate solution
  Was added to 1cm³ of the resulting solution followed by ammonia solution.

  Date posted: May 17, 2019 .    Answers (1)

• The standard electrode potentials for some half cells are given below. (Solved)
  

  The standard electrode potentials for some half cells are given below.
  
  i)Arrange the metals in order of reactivity.
  ii)Calculate the E.M.F of the cell shown below.
  
  iii) What would happen if a cell with chlorine and zinc ions, the anode was made
  of zinc. Explain your answer.

  Date posted: May 17, 2019 .    Answers (1)

• The set-up below represents electrolysis of dilute sulphuric (VI) acid. (Solved)
  

  The set-up below represents electrolysis of dilute sulphuric (VI) acid.
  
  (a) Identify gases M and N
  (b) Write an ionic equation for the production of gas M.
  (c ) At what electrode does reduction take place. Explain your answer.
  (d) State the most suitable electrodes that can be used in this experiment.
  Explain your answer.

  Date posted: May 17, 2019 .    Answers (1)

• Give the IUPAC names of the following compounds. (Solved)
  

  Give the IUPAC names of the following compounds.
  
  

  Date posted: May 17, 2019 .    Answers (1)

• The scheme below shows various reactions starting with ammonia. Study it and answer the questions that follow. (Solved)
  

  The scheme below shows various reactions starting with ammonia. Study it and
  answer the questions that follow.
  
  (i) List the raw materials used in the manufacture of ammonia.
  (ii) What catalyst is used in step I ?
  (iii) Write an equation for the reaction that occurs between ammonia and oxygen in
  presence of the catalyst.
  (iv) Identify the process in step II
  (v) Using an appropriate equation, explain how the reaction in step III occurs ?
  (vi) What should be added to solution K to form solid L ?
  (vii) (a) (i) Write the formula of compound J.
  (ii) Calculate the mass of compound J that would contain 14g of nitrogen
  ( H = 1, N = 14, O = 16 )
  (b) State two advantages of ammonium phosphate over ammonium nitrate.

  Date posted: May 17, 2019 .    Answers (1)

• The grid given below represents part of the periodic table. Study it and answer the questions that follow. The letters are not the actual symbols of... (Solved)
  

  The grid given below represents part of the periodic table. Study it and answer the questions
  that follow. The letters are not the actual symbols of the elements.
  
  (i) What name is given to the family of elements to which A and C belong?
  (ii) Write the chemical formula of the sulphate of element D.
  (iii ) Which letter represents the most reactive
  (a) Metal
  (b) Non-metal
  (iv) Name the bond formed when B and H react. Explain your answer.
  (v) Select one element that belong to period 4.
  (vi) Ionic radius of element E is bigger than the atomic radius. Explain.
  (vii) The electron configuration of a divalent anion of element N is 2.8.8. Induce the
  position of element N on the periodic table drawn above.
  (viii) The oxide of G has a lower melting point than the oxide of L. Explain.
  (ix) How do the atomic radii of I and C compare. Explain.
  (x) Explain the trend in the 1st ionization energies of the elements J, I and L.

  Date posted: May 17, 2019 .    Answers (1)

• Below are the bond dissociation energies of some elements. (Solved)
  

  Below are the bond dissociation energies of some elements.
  
  Use this information to calculate the heat of reaction for:-
  

  Date posted: May 17, 2019 .    Answers (1)

• Study the arrangement below and answer the question that follows. (Solved)
  

  Study the arrangement below and answer the question that follows.
  
  Explain what will be observed after some time.

  Date posted: May 17, 2019 .    Answers (1)

• The diagram below outlines industrial preparation of bleaching powder. (Solved)
  

  The diagram below outlines industrial preparation of bleaching powder.
  
  (i) Give the chemical name of bleaching powder
  (ii) Identify substance R
  (iii) Explain why water in which bleaching powder has been added needs a lot of soap
  during washing.

  Date posted: May 17, 2019 .    Answers (1)