Calculate the maximum speed at which the car can go round the bend without skidding if the coefficient of friction between the tyres and the...

Calculate the maximum speed at which the car can go round the bend without skidding if the coefficient of friction between the tyres and the ground is 0.5.

---

---

Kavungya answered the question on May 31, 2019 at 10:24

Exams With Marking Schemes

• Grade 1
• Grade 2
• Grade 3
• Grade 4
• Grade 5
• Grade 6
• Grade 7
• Grade 8
• Grade 9
• PP1
• PP2
• Playgroup
• Form 1
• Form 2
• Form 3
• Form 4

Related Questions

---

• A car goes round a flat circular bend whose radius is 100m at a constant speed of 30m/s. Calculate its acceleration (Solved)
  

  A car goes round a flat circular bend whose radius is 100m at a constant speed of 30m/s. Calculate its acceleration

  Date posted: May 31, 2019 .    Answers (1)

• The figure below shows details of an experiment performed by a student and the results taken. (take the density of water as 1.0g/cm³) i) Calculate the... (Solved)
  

  The figure below shows details of an experiment performed by a student and the results taken. (take the density of water as 1.0g/cm³)
  
  i) Calculate the volume of the metal block below the water
  ii) Calculate the new reading on the compression balance after the block is halfway immersed
  iii) Calculate the reading you would expect to obtain on the spring balance
  iv) Give a statement of the principle you have used in part (iii) above

  Date posted: May 31, 2019 .    Answers (1)

• The figure below shows a stone whirled in a horizontal circle. Use the information to distinguish between angular velocity and linear speed of the stone. (Solved)
  

  The figure below shows a stone whirled in a horizontal circle.
  
  Use the information to distinguish between angular velocity and linear speed of the stone.

  Date posted: May 31, 2019 .    Answers (1)

• A 50W heating coil is totally immersed in 100g of water contained in an insulated flask of negligible heat capacity. The initial temperature of water... (Solved)
  

  A 50W heating coil is totally immersed in 100g of water contained in an insulated flask of negligible heat capacity. The initial temperature of water in the flask is 20^oc.
  i) Determine how long it takes for the water to boil at 100^oC when the heater is switched on
  ii) After the water has been boiling for 15 minutes, it is found that the mass of water in the flask has decreased to 80g. Assuming no external heat losses, calculate a value for the specific latent heat of vaporization of water

  Date posted: May 31, 2019 .    Answers (1)

• The illustration below is used to produce a measured rise in temperature of a liquid using electrical energy. Explain why; i) The liquid will tend to be... (Solved)
  

  The illustration below is used to produce a measured rise in temperature of a liquid using electrical energy.
  
  Explain why;
  i) The liquid will tend to be warmer at the top of the container than at the bottom.
  ii) The temperature will eventually stop rising even though the current is still passing through the heating coil.
  iii) If the apparatus is used to determine the specific heat capacity of the liquid, the accuracy of the experiment will be increased if the liquid is first cooled to about 5^oc below room temperature and the current passed until the temperature is about 5^oc above room temperature.

  Date posted: May 31, 2019 .    Answers (1)

• You are provided with the following - Test-tube - Some sand - Spatula - Measuring cylinder with water - Spring balance Using diagrams describe an experiment to verify law of floatation. (Solved)
  

  You are provided with the following
  - Test-tube
  - Some sand
  - Spatula
  - Measuring cylinder with water
  - Spring balance
  Using diagrams describe an experiment to verify law of floatation.

  Date posted: May 31, 2019 .    Answers (1)

• A hole of area 2.0cm² at the bottom of a tank 5m deep is closed with a cork. Determine the force on the cork when... (Solved)
  

  A hole of area 2.0cm² at the bottom of a tank 5m deep is closed with a cork. Determine the force on the cork when the tank is filled with sea water of density 1.2g/cm³.

  Date posted: May 31, 2019 .    Answers (1)

• The figure below shows a block of 5kg pulled up with a force of 30N through an inclined plane at 30°. If the surface has a... (Solved)
  

  The figure below shows a block of 5kg pulled up with a force of 30N through an inclined plane at 30°.
  
  If the surface has a co-efficient of 0.4m find:
  i) Frictional force.
  ii) Acceleration of the block.
  iii) Given that the distances AB = l and BC = h, show that the velocity ratio of the incline is equal to 2.0.

  Date posted: May 31, 2019 .    Answers (1)

• Sketch a graph of pressure against temperature on the Celsius scale. On the same axis sketch another graph for a gas of a larger volume. (Solved)
  

  Sketch a graph of pressure against temperature on the Celsius scale. On the same axis sketch another graph for a gas of a larger volume.

  Date posted: May 31, 2019 .    Answers (1)

• A certain mass of hydrogen gas occupies a volume of 1.6m³ at a pressure of 1.5 × 10⁵ Pa and a temperature of 22⁰c.Determine the... (Solved)
  

  A certain mass of hydrogen gas occupies a volume of 1.6m³ at a pressure of 1.5 × 10⁵ Pa and a temperature of 22⁰c.
  Determine the volume when the temperature is 0⁰c at a pressure of 0.8×10⁵ Pa.

  Date posted: May 31, 2019 .    Answers (1)

• An electric kettle with a 2.0kw heating element has a heat capacity of 400j/k. 1.0kg of water at 20°C is placed in the kettle. The... (Solved)
  

  An electric kettle with a 2.0kw heating element has a heat capacity of 400j/k. 1.0kg of water at 20°C is placed in the kettle. The kettle is switches on and it is found that 13 minutes later the mass of water in it is 0.5kg. Ignoring heat losses ; calculate
  i) Total heat supplied.
  ii) Heat used for the kettle.
  iii) Heat used to raise temperature of 1kg of water from 20°C to 100°C.
  iv) Heat to change water at 100°C to steam at 100°C.
  v) The specific latent heat of vaporization of water.

  Date posted: May 31, 2019 .    Answers (1)

• A glass capillary contains enclosed air by a thread of mercury 15cm long when the tube is horizontal, the length of the enclosed air column... (Solved)
  

  A glass capillary contains enclosed air by a thread of mercury 15cm long when the tube is horizontal, the length of the enclosed air column 24cm as shown.
  
  i) What is the length of the enclosed air column when the tube is vertical with the open end uppermost if the atmosphere pressure is 750mmHg?
  ii) Explain why the mercury does not run out when the tube is vertical with the closed end uppermost.

  Date posted: May 31, 2019 .    Answers (1)

• A car of mass 800g is initially moving at 25m/s. Calculate the force needed to bring the car to rest over a distance of 20m. (Solved)
  

  A car of mass 800g is initially moving at 25m/s. Calculate the force needed to bring the car to rest over a distance of 20m.

  Date posted: May 31, 2019 .    Answers (1)

• A bob of mass 20kg is suspended using a string of 4m from a support and swings through a vertical height of 0.9m as shown... (Solved)
  

  A bob of mass 20kg is suspended using a string of 4m from a support and swings through a vertical height of 0.9m as shown below:
  
  Determine:
  i) The potential energy of the body at its position.
  ii) Speed of the body when passing through the lowest point.

  Date posted: May 31, 2019 .    Answers (1)

• A cork enclosing steam in a boiler is held down by the system shown. If the area of the cork is 15 cm² and a force... (Solved)
  

  A cork enclosing steam in a boiler is held down by the system shown.
  
  If the area of the cork is 15 cm² and a force (F) of 500N is needed to keep the cork in place, determine the pressure of the steam in the boiler.

  Date posted: May 31, 2019 .    Answers (1)

• In an experiment to determine the thickness of an oil molecule, an oil drop of volume 3.60 x 10^-6 m³ was observed to form a... (Solved)
  

  In an experiment to determine the thickness of an oil molecule, an oil drop of volume 3.60 x 10^-6 m³ was observed to form a circular patch of diameter 0.016m on the surface of water covered with lycopodium powder
  i). Explain why the oil drop forms a circular patch.
  ii) Determine the thickness of the oil molecule

  Date posted: May 31, 2019 .    Answers (1)

• The figure below shows a uniform plank AB of length 10m weighing 500N. Two masses measuring 25kg and 60kg are loaded on its ends. Determine the... (Solved)
  

  The figure below shows a uniform plank AB of length 10m weighing 500N. Two masses measuring 25kg and 60kg are loaded on its ends.
  
  Determine the distance from point A where a support should be placed for the plank to balance horizontally.

  Date posted: May 31, 2019 .    Answers (1)

• A small drop of oil has a volume of 5 × 10^-8m³. When it is put on the surface of some clean water, it forms... (Solved)
  

  A small drop of oil has a volume of 5 × 10^-8m³. When it is put on the surface of some clean water, it forms a circular film of 0.1m² in area; what is the size the a molecule oil.

  Date posted: May 31, 2019 .    Answers (1)

• The diagram below shows a gas cooker thermostat Briefly explain how the thermostat works (Solved)
  

  The diagram below shows a gas cooker thermostat
  
  Briefly explain how the thermostat works

  Date posted: May 31, 2019 .    Answers (1)

• The distance between the ice point and steam point on a liquid in glass thermometer is 30cm. what temperature is recorded when the mercury thread... (Solved)
  

  The distance between the ice point and steam point on a liquid in glass thermometer is 30cm. what temperature is recorded when the mercury thread is 12cm above the ice point?

  Date posted: May 31, 2019 .    Answers (1)