-
A force of 20N is used to stretch a spring through 5cm. Calculate the elastic potential energy stored in the spring.
(Solved)
A force of 20N is used to stretch a spring through 5cm. Calculate the elastic potential energy stored in the spring.
Date posted:
September 6, 2019
.
Answers (1)
-
A pipe of radius 3mm is connected to another pipe of radius 9mm. If water flows in the water pipe at a speed of 2m/s,...
(Solved)
A pipe of radius 3mm is connected to another pipe of radius 9mm. If water flows in the water pipe at a speed of 2m/s, what is the speed in the narrower pipe?
Date posted:
September 6, 2019
.
Answers (1)
-
A uniform 120m metal rod is pivoted near one of its ends and kept in equilibrium by a spring balance as shown in the figure...
(Solved)
A uniform 120m metal rod is pivoted near one of its ends and kept in equilibrium by a spring balance as shown in the figure below.
The reading indicated by the spring balance is 2.0N. Work out the mass of the metal rod. (g = 10N/kg)
Date posted:
September 6, 2019
.
Answers (1)
-
The spiral springs shown in the figure below are identical. Each spring has a constant K = 300N/m.
Determine the extension caused by the 150N weight...
(Solved)
The spiral springs shown in the figure below are identical. Each spring has a constant K = 300N/m.
Determine the extension caused by the 150N weight (Ignore weight of springs and connecting rods)
Date posted:
September 6, 2019
.
Answers (1)
-
A micrometer screw gauge has a zero error of -0.02mm. It is used to measure the diameter of a wire. If the actual diameter of...
(Solved)
A micrometer screw gauge has a zero error of -0.02mm. It is used to measure the diameter of a wire. If the actual diameter of the wire is 0.28mm. Draw the micrometer screw gauge showing the diameter of the wire.
Date posted:
September 6, 2019
.
Answers (1)
-
A girl performed an experiment to measure the focal length of a converging mirror.In the experiment, a series of object distance,U(cm) and image distance V(cm)...
(Solved)
A girl performed an experiment to measure the focal length of a converging mirror.In the experiment, a series of object distance,U(cm) and image distance V(cm) were obtained and the graph UV cm2 against V+U obtained as shown below.
Use the graph to determine:
i) Focal length of the mirror.
ii) Radius of curvature.
iii) State two applications of diverging mirror.
iv) Explain how a concave mirror is used by a dentist to enlarge image of the tooth.
Date posted:
August 22, 2019
.
Answers (1)
-
The figure below shows a standing wave formed when a string of length 1.5 m stretched between two supports is plucked in the middle.
(Solved)
The figure below shows a standing wave formed when a string of length 1.5 m stretched between two supports is plucked in the middle.
(i) Explain how the standing wave is formed
(ii) Determine the wavelength of the standing wave
Date posted:
August 22, 2019
.
Answers (1)
-
The figure below shows crests of circular water waves spreading from two points A and B due to a vibrator. C and D are points...
(Solved)
The figure below shows crests of circular water waves spreading from two points A and B due to a vibrator. C and D are points on the surface of the water.
Given that the amplitude of each wave is 5 cm, state with a reason the amplitudes of the waves at point:
(i) C
(ii) D
Date posted:
August 22, 2019
.
Answers (1)
-
Sodium has a work function of 2.3eV. Given that: Planck’s constant h = 6.63 x 10-34JS, velocity of light in vacuum, C = 3.0 x108m/s,...
(Solved)
Sodium has a work function of 2.3eV. Given that: Planck’s constant h = 6.63 x 10-34JS, velocity of light in vacuum, C = 3.0 x108m/s, 1 electron-volt (1eV) = 1.6 x 10-19 C and mass of an electron, me = 9.1 x 10-31kg, calculate:
(i) Its threshold frequency.
(ii) The maximum velocity of the photoelectrons produced when the sodium is illuminated by light of wavelength 5.0 x 10-7m.
(iii) The stopping potential V, with the light of this wavelength.
Date posted:
August 22, 2019
.
Answers (1)
-
A G.M tube indicated a constant count rate of 5 counts per minute when a radioactive source was placed at a distance of about 10...
(Solved)
A G.M tube indicated a constant count rate of 5 counts per minute when a radioactive source was placed at a distance of about 10 cm from it. When the source was moved close to about 4cm the count rate varied as follows.
(i) The count rate was constant at a distance of 10 cm away. Explain
(ii) Plot a graph of count rate against time.
(iii) Use your graph to estimate the half-life of the radioactive source.
(iv) 
(v) State two precautions that have to be observed when using a radioactive substance.
(vi) Distinguish between fission and fusion.
Date posted:
August 22, 2019
.
Answers (1)
-
The figure below shows a circuit.
(Solved)
The figure below shows a circuit.
Calculate:
i) The total resistance of the circuit.
ii) The total current flowing in the circuit.
iii) The voltage drop across resistor R1.
iv) The current through the 3Ω resistor.
Date posted:
August 22, 2019
.
Answers (1)
-
The figure below shows a current carrying wire at right angle to a cardboard. Iron fillings are sprinkled on the card and card slightly tapped.
(Solved)
The figure below shows a current carrying wire at right angle to a cardboard. Iron fillings are sprinkled on the card and card slightly tapped.
Draw and indicate the direction of the magnetic field pattern displayed on the card.
Date posted:
August 22, 2019
.
Answers (1)
-
Explain the behavior of the pins as illustrated below
(Solved)
Explain the behavior of the pins as illustrated below
Date posted:
August 22, 2019
.
Answers (1)
-
A house has a lighting circuit operated from a 240V mains supply. Four bulbs rated 40W 240V and six bulbs rated 100W 240V are switched...
(Solved)
A house has a lighting circuit operated from a 240V mains supply. Four bulbs rated 40W 240V and six bulbs rated 100W 240V are switched on for 5 hours a day. Determine the monthly bill for the consumer given that the cost of electricity is at shs. 5.50 per unit.
(Take 1 month = 30 days and the standing charge is sh. 150)
Date posted:
August 22, 2019
.
Answers (1)
-
A girl standing at a distance claps her hands and hears an echo from a tall building 2 seconds later. If the speed of sound...
(Solved)
A girl standing at a distance claps her hands and hears an echo from a tall building 2 seconds later. If the speed of sound in air is 340m/s, determine how far the building is.
Date posted:
August 22, 2019
.
Answers (1)
-
The figure below shows refraction of light at air-water interface.
(Solved)
The figure below shows refraction of light at air-water interface.
Determine angle Ө if the refractive index of water is 1.33
Date posted:
August 22, 2019
.
Answers (1)
-
Water of mass 3.0kg initially at 200c is heated in an electric kettle rated 3.0kw. The water is heated until it boils at 1000c. (Take...
(Solved)
Water of mass 3.0kg initially at 200c is heated in an electric kettle rated 3.0kw. The water is heated until it boils at 1000c. (Take specific heat capacity of water = 4200Jkg-1k-1, Heat capacity of kettle = 450Jk-1, and specific latent heat of vaporization of water = 2.3MJkg-1)
Determine;
(i) The heat absorbed by water.
(ii) The heat absorbed by the electric kettle.
(iii) The time taken by water to boil.
(iv) How much longer will it take to evaporate all the water?
Date posted:
August 22, 2019
.
Answers (1)
-
The figure below shows a toy car moving in a circular rail in a vertical plane. The mass of the toy car is 300g and...
(Solved)
The figure below shows a toy car moving in a circular rail in a vertical plane. The mass of the toy car is 300g and the radius of the rail is 2m.
Determine:
i) Minimum velocity at which the toy passes point A
ii) If the toy was tied by a string at the centre of the rail path, following the same circular path, when whirled at which position (A or B) would the string experience maximum tension. Explain your answer.
iii) If the toy moves with a velocity of 5m/s as it passes point B, find the angular velocity at this point.
iv) State two applications of uniform circular motion
Date posted:
August 22, 2019
.
Answers (1)
-
The diagram in the figure below represents a wheel and axle used as a machine, whose efficiency is 80% to raise 400N of building materials....
(Solved)
The diagram in the figure below represents a wheel and axle used as a machine, whose efficiency is 80% to raise 400N of building materials. The wheel and axle have diameters of 75cm and 15cm respectively.
(i) Mark on the diagram the correct position and direction of the load to be lifted.
(ii) Name the principle on which this machine works.
(iii) Calculate the effort needed to raise the load.
(iv) The machine is operated manually and raises the load to a height of 5m in 20 seconds. Calculate the power developed by the operator
Date posted:
August 22, 2019
.
Answers (1)
-
A simple hydrometer is set up with a test –tube of mass 10g and length 12cm with a flat base and partially filled with lead...
(Solved)
A simple hydrometer is set up with a test –tube of mass 10g and length 12cm with a flat base and partially filled with lead shots. The test – tube has a uniform cross – sectional area of 2.0cm2 and 10cm of its length is under water as shown in the figure below.
(i) Determine the mass of lead shots in the test – tube (Take density of water = 1000kgm-3)
(ii) Calculate the mass of the lead shots to be added if the test – tube has to displace an equal volume of a liquid of density 1.25gcm-3.
(iii) What is the function of the lead shots?
Date posted:
August 22, 2019
.
Answers (1)