An experiment was set as shown below

An experiment was set as shown below


(a) Name the gas F
(b) State one physical characteristic of gas F.
(c ) What would be observed if a litmus paper was put in a solution of gas F.

---

(a) Chlorine gas

(b) - Greenish – yellow gas
- Unpleasant chocking smell
- Denser than air
- Fairly soluble in water

(c) Blue litmus paper turned red then to white.

---

maurice.mutuku answered the question on September 17, 2019 at 07:11

Exams With Marking Schemes

• Grade 1
• Grade 2
• Grade 3
• Grade 4
• Grade 5
• Grade 6
• Grade 7
• Grade 8
• Grade 9
• PP1
• PP2
• Playgroup
• Form 1
• Form 2
• Form 3
• Form 4

Related Questions

---

• The table below shows the observations made on tests carried out on a colourless liquid sample. (Solved)
  

  The table below shows the observations made on tests carried out on a colourless liquid sample.
  
  
  (a) Identify (i) Cation in the sample
  (ii) Anion in the sample
  (b) Write the ionic equation for the reaction taking place in experiment (III).

  Date posted: September 17, 2019 .    Answers (1)

• Study the flow chart below and answer the question that follow. (Solved)
  

  Study the flow chart below and answer the question that follow.
  
  (a) Identify substances P and Q
  (b) What name is given to the type of reaction in step 2 ?

  Date posted: September 17, 2019 .    Answers (1)

• The data below was recorded when metal K was completely burnt in air. K is not the actual symbol of the metal. (R.A.M; K = 56,... (Solved)
  

  The data below was recorded when metal K was completely burnt in air. K is not the actual symbol of the metal.
  (R.A.M; K = 56, O = 16 )
  Mass of empty crucible and lid = 10.240g
  Mass of crucible, lid and metal K = 10.352g
  Mass of crucible, lid and metal oxide = 10.400g
  (a) Determine the mass of
  (i) Metal K
  (ii) Oxygen
  (b) Determine the empirical formula of the metal oxide.

  Date posted: September 17, 2019 .    Answers (1)

• 60cm³ of oxygen gas diffused through a porous partition in 50 seconds. How long will it take 120cm³ of sulphur (IV) oxide gas to diffuse... (Solved)
  

  60cm³ of oxygen gas diffused through a porous partition in 50 seconds. How long will it take 120cm³ of sulphur (IV) oxide gas to diffuse through the same partition under the same conditions.

  Date posted: September 17, 2019 .    Answers (1)

• In an experiment magnesium ribbon was reacted with dilute sulphuric (VI) acid and the volume of hydrogen gas produced with time noted. The graph below... (Solved)
  

  In an experiment magnesium ribbon was reacted with dilute sulphuric (VI) acid and the volume of hydrogen gas produced with time noted. The graph below shows the volume of gas produced with time
  
  
  Explain the following observations.
  (i) The curve of the graph is steepest at the beginning.
  (ii) The curve of the graph completely flattens at region AB.
  (iii) On the same axis plot the curve that would be obtained if the acid used was ethanoic acid. Label it ethanoic acid

  Date posted: September 17, 2019 .    Answers (1)

• The equation below represents a redox reaction. (Solved)
  

  The equation below represents a redox reaction.
  
  2FeCl_{2 (aq)} + Cl_{2 (g)}----->2FeCl_{3 (aq)}
  
  Identify the oxidizing agent. Give a reason.

  Date posted: September 17, 2019 .    Answers (1)

• The table below gives the solubility of potassium bromide and potassium sulphate at 0⁰C and 80⁰C. (Solved)
  

  The table below gives the solubility of potassium bromide and potassium sulphate at 0⁰C and 80⁰C.
  
  
  When an aqueous mixture containing 60g of potassium bromide and 7g of potassium sulphate in 100g of water was cooled from 80⁰C to 0⁰C, some crystals were formed.
  (a) Identify the crystals.
  (b) Determine the mass of crystals formed.
  (c) Name the method used to obtain the crystals.

  Date posted: September 17, 2019 .    Answers (1)

• Describe how solid Aluminium chloride can be separated from a solid mixture of sodium chloride and ammonium chloride. (Solved)
  

  Describe how solid Aluminium chloride can be separated from a solid mixture of sodium chloride and ammonium chloride.

  Date posted: September 17, 2019 .    Answers (1)

• The diagram below shows spots of pure substances A, B and C on a chromatography paper. Spot D is that of a mixture. After development A,... (Solved)
  

  The diagram below shows spots of pure substances A, B and C on a chromatography paper. Spot D is that of a mixture.
  After development A, B and C were found to have moved 9cm, 4cm and 7cm respectively D has separated into two spots which moved 7cm and 9cm.
  
  
  (a) On the diagram
  (i) Using 5 units in the alongside scale to represent 1cm Show the position of all the spots after development.
  
  (ii) Identify the substances present in mixture D.

  Date posted: September 17, 2019 .    Answers (1)

• The relative atomic mass of an element is 10.28. (Solved)
  

  The relative atomic mass of an element is 10.28, it has two isotopes
  Calculate the relative percentage abundance of each isotope.

  Date posted: September 17, 2019 .    Answers (1)

• The atomic number of Q and R are 9 and 17 respectively. Compare the electron affinity of Q and . Explain. (Solved)
  

  The atomic number of Q and R are 9 and 17 respectively. Compare the electron affinity of Q and . Explain.

  Date posted: September 17, 2019 .    Answers (1)

• In order to determine the molar heat of neutralization of 1M potassium hydroxide, 200cm³ of 1M hydrochloric acid both at the same temperature were mixed... (Solved)
  

  In order to determine the molar heat of neutralization of 1M potassium hydroxide, 200cm³ of 1M hydrochloric acid both at the same temperature were mixed and stirred continuously with a thermometer. The temperature of the resulting solution was recorded after every 30 seconds until the highest temperature of the solution was attained.
  
  (a) (i) Why was it necessary to stir the mixture of the two solutions?
  (ii) Write an ionic equation for the reaction.
  
  (b) The initial temperature for both solution was 24.5°C and the highest temperature attained by the mixture was 30.9°C. Calculate the
  (i) heat change for the reaction.
  (Specific heat capacity of the solution is Density of the solution is
  The volume of KOH used was 200cm³.
  (ii) molar heat of the neutralisation.
  
  (c) If ammonium hydroxide was used instead of potassium hydroxide the heat of neutralization would be different from the one obtained in b(ii) above.
  Explain the difference.
  
  (d) Draw an energy level diagram for the reaction between potassium hydroxide and hydrochloric acid.

  Date posted: September 16, 2019 .    Answers (1)

• Explain why lead carbonate is not reacted with dil. H₂SO₄ in preparation of carbon (IV) oxide in the laboratory. (Solved)
  

  Explain why lead carbonate is not reacted with dil. H₂SO₄ in preparation of carbon (IV) oxide in the laboratory.

  Date posted: September 16, 2019 .    Answers (1)

• The table below shows ammeter readings obtained where different electrolytes of the same concentration were tested. (Solved)
  

  The table below shows ammeter readings obtained where different electrolytes of the same concentration were tested.
  
  Explain why ethanoic acid gave a lower ammeter reading the copper (II) sulphate solution.

  Date posted: September 16, 2019 .    Answers (1)

• Study the scheme given below and answer the questions that follow. (Solved)
  

  Study the scheme given below and answer the questions that follow.
  
  (i) Write an equation for the reaction between propan-l-ol and potassium metal.
  (ii) Name process I and II.
  (iii) Identify the products A and B.
  (iv) Name one catalyst used in Process II.
  (v) Draw the structural formula of the repeating unit in the polymer C.
  (vi) Write the structural formula of 2, 3-dichloropropene.

  Date posted: September 16, 2019 .    Answers (1)

• The grid below shows part of the periodic table. Use it to answer questions that follow. The letters do not represent the actual symbols of... (Solved)
  

  The grid below shows part of the periodic table. Use it to answer questions that follow. The letters do not represent the actual symbols of the elements.
  
  (a) (i) Which of the element has the lowest ionization energy?
  (ii) Explain your answer in a(i) above.
  (b) (i) Identify the most reactive non-metal.
  (ii) Explain your answer in b(i) above.
  (c) Give the electronic configuration of element.
  (i) S
  (ii) Q
  (d) Compare the atomic radius of P and R. Explain.
  (e) The mass number of W is 40. Write down the composition of its nucleus.
  (f) Write formula of oxides of P.
  (g) (i) What is the name given to elements found in the shaded region.
  (ii) Which elements can be used to provide an inert environment?

  Date posted: September 16, 2019 .    Answers (1)

• (a) Using electrons in the outermost energy level, draw and cross (x) diagram for H3O⁺ and C₂H₄ (H = 1, C = 6,O =... (Solved)
  

  (a) Using electrons in the outermost energy level, draw dots and crosses (x) diagram for H3O⁺ and C₂H₄ (H = 1, C = 6,
  O = 16)
  
  (b) What would be the effect of dipping litmus paper in aqueous solution of H3O⁺?

  Date posted: September 16, 2019 .    Answers (1)

• The diagram below represent large scale manufacture of hydrochloric acid. Study it and answer the questions that follow. (Solved)
  

  The diagram below represent large scale manufacture of hydrochloric acid.
  Study it and answer the questions that follow.
  
  
  (a) Identify.
  (i) Gas A
  (ii) Gas B
  
  (b) Write the chemical equation for the reaction between gas A and B.

  Date posted: September 16, 2019 .    Answers (1)

• The equation below represent equilibrium reaction between chromate ions and dichromate ions. (Solved)
  

  The equation below represent equilibrium reaction between chromate ions and dichromate ions.
  
  State and explain the observation made if dilute sulphuric (VI) acid is added to the equilibrium mixture.

  Date posted: September 16, 2019 .    Answers (1)

• A student was provided with 1.5g of XCO₃. He reacted it with 50cm³ of 1M HCl which was excess. Determine the volume of CO₂ produced... (Solved)
  

  A student was provided with 1.5g of XCO₃. He reacted it with 50cm³ of 1M HCl which was excess. Determine the volume of CO₂ produced at S.T.P.
  (R.F.M of x CO₃ = 100) molar gas volume at S.T.P = 22400cm³.

  Date posted: September 16, 2019 .    Answers (1)