-
In the mechanism shown in figure below, the crank EF rotates about centre E while GH oscillates about G.
Plot the locus of point P for one complete revolution of EF.
Date posted:
October 17, 2019
-
Figure below shows the three orthographic views of a machined block drawn in first angle projection.
Draw full size, the isometric view of the block taking corner X as the lowest point.
Date posted:
October 17, 2019
-
Figure below shows parts of a machined component drawn in first angle projection.
Assemble the parts and draw the following:
a)Sectional front elevation through the cutting plane F-F.
b)The plan.
Date posted:
October 17, 2019
-
A right square pyramid is truncated along X-X and Y –Y as shown in figure below.
Complete the plan
Date posted:
October 17, 2019
-
Figure below shows two views of a block drawn in first angle projection. In good proportionality sketch the block in oblique projection.
Date posted:
October 17, 2019
-
State one disadvantage of using each of the following items to hold paper on the drawing board .
(i)Masking tape.
(ii)Thumb pins
Date posted:
October 17, 2019
-
Give four major characteristics of mosaic technique of picture making.
Date posted:
September 13, 2019
-
Outline 5 factors to consider in sculpture placement.
Date posted:
August 19, 2019
-
Explain any 4 factors that should be considered in designing ornaments.
Date posted:
August 5, 2019
-
List two main uses of voids in a sculpture.
Date posted:
August 5, 2019
-
List any three factors to be considered when designing an ornament.
Date posted:
April 2, 2019