Technical Drawing Question Paper

Technical Drawing

Course:

Institution: Nyeri Technical Training Institute question papers

Exam Year:2009

Nyeri Technical Training Institute
Department Of Automotive Engineering
Craft In Motor Vehicle Mechanics
CAT 1
Technical Drawing
Time 1hour

Instructions
1. You are required to have the following for this examination.
i) Question paper
ii) Answer sheet
iii) Drawing instruments
2. This paper consists of THREE questions.
3. Attempt all questions.

1. a) State the use of the following drawing instruments.
i) T- square
ii) French curve
iii) Divider
iv) Drawing board
v) Eraser
(5 marks)
b) State any FIVE types of line appropriate pencils use for construction of these lines.
(5 marks)
2. a) State any Three uses of scale in technical drawing
(3 marks)
b) Describe any THREE sizes of scale giving the correct ratios for each scale size
(7 marks)

3. Construct a plain scale 20 mm represent 100 mm if the largest dimension is 500mm.
(10 marks)

📘 Access 10,000+ CBC Exams With Marking Schemes

Technical Drawing Question Paper

More Question Papers

Exams With Marking Schemes

End Term 3 Exams

Mid Term Exams

End Term 1 Exams

Opener Exams

Full Set Exams